Add text and notes to a Fusion drawing
Add text and notes to a drawing in Fusion.
Tutorial resources
These downloadable resources will be used to complete this tutorial:
In this activity, you will add text and notes to the drawing.
Prerequisites
- If you've not completed "Add dimensions", download and open
main-pump-body-drawing-activity-4.f3z
 to continue.
Steps-by-step:
-
Create a General Note for the drawing.
- Select the Note command.
- Under the Section View, click the pointer.
- Drag down and to the right to create a text box, when you get to a good size click again to start the Note.
- Add the following text to the Note:
GENERAL NOTES
REMOVE ALL BURRS AND SHARP EDGES
ALL FILLETS AND ROUNDS R6 UNLESS OTHERWISE SPECIFIED
-
Add hole notes.
- Select the Notes command.
- Select the top-left hole in the Projected View.
- Pull the pointer away from the hole to see the preview of the hole note.
- Click to place the hole note.
- Repeat the last three steps for Section View B-B and Detail View holes.
-
Add a note.
- With the Notes command still active, click the radius next to the hole in the Detail View.
- Move the pointer up and to the right and click to place the Note.
- Add the following text to the note:
CHECK FOR A MINIMUM THICKNESS OF 2MM
Activity 4 summary
In this activity, you added text and notes to the drawing.
Before text and notes (left). After text and notes (right).